Step 1

Place the diffuser on a flat and stable table. Remove the Crown Shade and Snuffer Cap from the diffuser.

Using a funnel  pour in your fuel/oil until it is 2/3 full. Wipe away any spilled fuel/oil  off surface of the diffuser or table top as it can remove the finish on your table.

Step 2

Mount the diffusing head (burner) tightly onto the diffuser wick-first, dipping the wick into the essential oil. Put back on the snuffer cap and wait for about 15 - 25 minutes to allow the essential oi/fuel to soak the wick thoroughly.

Step 3

Remove the snuffer cap, light up the diffusing wick/stone and let the flame heat up the diffusing head for about 2 – 3 minutes. Flame will be high.

Step 4

Put out the flame by blowing on flame. The diffuser wick stone is now heated to the correct temperature to diffuse the essential oil into the air.

Step 5

Place the Crown (Shade) not the metal cap back on the diffuser for protection so as to prevent touching the hot diffusing wick/stone.   

Step 6

To shut down (turn off) put out the diffuser, simply place the metal cap over the diffusing head (be careful not to touch the hot wick/stone diffusing head!).

This will stop the diffusion and prevent loss of essential oil through evaporation.

Tips:

Never touch the diffusing wick/stone burner head with your fingers during diffusion; its extremely hot.

If stone/wick touches anything while hot it can start a fire as it is very very hot.

I recommend cleaning wick between each scent/fragrance change you make as mixing different oils can cause wick to clog. 

To clean take wick cord and stone this is everything and put in a pint jar of 91 or 99% alcohol and soak for 2 or 3 hours or longer.  Then lay out to air dry.

Or you can take alcohol and burn in your lamp.  One burning should clean the wick and stone.

Place the diffuser out of children's reach and away from any sources of heat.

Will cause severe burns if touch wick/stone while hot.